Gutters and Downspouts cleaning.
The roof gutters that line the overhanging eaves are an important part of the roofing system, especially in Ontario. The system helps protect against wood rot and failure at the roof fascia boards and siding, and it also helps keep your basement or crawlspace dry by directing water well away from the foundation. Along with the downspouts and extensions, the gutter system ensures the proper flow of water off the roof and away from the home’s foundation. Gutters and downspouts can get clogged with leaves and debris that hinder the proper operation of the system, so keeping them clean.
Fortunately, cleaning gutters and downspouts is not a hard job, and a couple of cleanings each year should keep them flowing freely. This job does, however, involve working on a ladder. Make sure you have a sturdy extension ladder that is long enough to reach the edge of your roof and always follow safe practices when using a ladder. Make sure the base of the ladder rests on a solid, level surface, and avoid leaning out away from the ladder. You will need Ladder, Plastic bucket with a wire handle, Leaf scooper, Garden hose, Plumber’s snake (if necessary).
The first thing you need to decide is how you’re going to collect the leaves and other matter you remove from the gutters. The method will vary, depending on if the material in the gutters is damp and soggy, or loose and dry.
If Gutter Contents Are Damp.
Cleaning gutters is less messy when the contents are dry and loose, but sometimes you need to clean them while the debris is wet. When gutter contents are wet, you can either use what might be called the scoop and drop method or the gutter bucket method.
Scoop and Drop.
The scoop and drop method involves scooping out the gutter and dropping the contents onto a plastic tarp or drop cloth lying on the ground below. This method is fastest, and all you have to do is move the plastic tarp along the ground with you as you move the ladder. When the tarp gets full, just dump the leaves into your compost bin or trash bag.
The gutter bucket method is fairly common and involves using a plastic bucket with a metal handle. Cut the handle in two at the center. Then, bend the ends of the handle halves into hook shapes that you then hook onto the edge of the gutter. You simply scoop out the debris from the gutter and empty it into the bucket. Be ready to do a lot of climbing up and down the ladder to empty the bucket as you fill it.
If Gutter Contents Are Dry
When you have dry gutter contents a better way to clean out and collect the dried leaves and sticks is what might be called the gutter bag method.
Gutter Bag Method
With the gutter bag method, take a plastic bucket and cut and bend the handle so it can be hooked over the edges of the gutters as you work. Here, you will also cut off the bottom of the bucket, creating a bottomless bucket.
Now, fasten a trash bag around the bucket just under the metal handle. You can fasten it tightly with a large rubber band, duct tape or a large Velcro strap. As you scoop dry leaves into the bucket, they will funnel down into the trash bag. This method works well with dry leaves that are bulky but light, but it will not work with heavy, wet gutter debris.
Make sure not to overfill the bag so it is too heavy to easily carry down the ladder. Use good judgment with safety in mind whenever working on a ladder.
After you have chosen your bucket method, now it’s time for the productive part—cleaning the gutters. You can use any number of things to scoop the contents out of a gutter and into your bucket. You can fabricate your own scooper from a plastic jug with a handle, but a trowel or garden spade works just as well. You can even use old kitchen tools, such as a spatula.
Work in short sections along the gutters, and don’t overreach. Keep your body upright, and reach only as far as you can without leaning away from the ladder. You will need to move the ladder frequently, but safety is critical here.
Note: Extension ladders are typically best when working along the edge of the roof, and are the only option when working a two-story house. With a single-story house, you may be able to do this work on a tall stepladder. Whatever ladder you use, never climb above the top-level stipulated by the ladder manufacturer. If you don’t have a ladder long enough to safely do the job, rent or borrow one that is.
Once the roof gutters are cleared of debris, make sure the downspouts are cleared. If your downspouts have horizontal extension pipes, remove these to clear the downspouts.
Take a hose and place it into the downspout from the top opening where the gutters feed into it. Have a helper turn on the water and check for downspout flow. If the downspout is clogged, clear it out:
Pack the downspout opening around the hose with a rag, sealing the hose tight.
Turn on the water spigot wide open to create as much pressure as possible. Watch the end of the downspout for the clog to clear.
If the clog persists, remove the hose and manually clear it using a plumbing snake. Feed the snake from the top of the downspout until it hits the obstruction, which is usually at the point of a curve in the downspout pipe.
Once you think you have the downspout cleared, test the flow by running water through it.
If your downspouts have horizontal extension pipes, also check them for clogs and clear any obstructions you find.